Technical data

WAGO-I/O-SYSTEM 750 Commissioning 49
750-652 Serial Interface RS-232 / RS-485
Manual
Version 1.3.0
8 Commissioning
8.1 Configuration and Parameterization with
WAGO-I/O-CHECK
The serial interface module is configured with the WAGO-I/O-CHECK software
(version 3.3 or higher, WAGO-I/O-CHECK version 3.5.3 is required for firmware
version 03 or higher). The software's basic functionality is described separately in
the WAGO-I/O-CHECK documentation.
Component damage due to incorrect voltage level!
Incorrectly selected voltage levels can destroy the device!
Note when switching between operating modes that RS-232 and RS-485 use
different voltage levels.
Switch off connected devices before changing operating modes!
Make sure that devices you connect support the voltage level of the current
operating mode!
8.1.1 RS-232 / RS-485 Serial Interface (Configuration Dialog)
Figure 17: Parameter Dialog