Service manual

2
XV-Z90U
DT-200
Specifications
This SHARP projector uses a DMD chip. This very sophisticated chip
contains 480,000 pixels. As with any high technology electronicequipment
such as large screen TVs, video systems and videocameras, there are
certain acceptable tolerances that the equipment must conform to.
This unit has some inactive pixels within acceptable tolerances which
may result in inactive dots on the picture screen. This will not affect the
picture quality or the life expectancy of the unit. If you have any ques-
tions about this matter, please call toll free 1-877-DTV-SHARP (1-877-
388-7427). U.S.A. ONLY
Specifications are subject to change without notice.
Product type Theater Projector
Model XV-Z90U/DT-200
Video system PAL/PAL 60/PAL-M/PAL-N/SECAM/NTSC 3.58/NTSC 4.43/DTV 480i/480P/720P/1080i
Display method DLP chip, RGB optical shutter method
DLP panel Panel size: 0.55” (140mm)
Display method: Single Panel Digital Micromirror Device (DMD™) by Texas Instruments
Drive method: Digital Light Processing (DLP)
No. of dots: 480,000 dots (800 [H] x 600 [V])
Lens 1–1.2 x zoom lens, F1.75–2.04, f=28–33.5 mm (XV-Z90U) F2–2.4, f=16.9–20.2 mm (DT-200)
Projection lamp DC150 W SHP lamp
Video input signal RCA Connector: VIDEO (INPUT 4), composite video, 1.0 Vp-p, sync negative, 75 Ω terminated
S-video input signal 4-pin Mini DIN connector (INPUT 3)
Y (luminance signal): 1.0 Vp-p, sync negative, 75 Ω terminated
C (chrominance signal): Burst 0.286 Vp-p, 75 Ω terminated
Component input signal RCA Connector
(INPUT 1) Y: 1.0 Vp-p, sync negative, 75 Ω terminated
PB: 0.7 Vp-p, 75 Ω terminated
PR: 0.7 Vp-p, 75 Ω terminated
Component input signal 29-pin connector
(INPUT 2) DVI input signal: Digital 250–1,000 mV 50 Ω
Analog 0.7 Vp-p 75 Ω
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
PB: 0.7 Vp-p, 75 Ω terminated
PR: 0.7 Vp-p, 75 Ω terminated
Component RGB input signal 29-pin connector
(INPUT 2) RGB separate/sync on green type analog input: 0–0.7 Vp-p, positive, 75 Ω terminated
HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative)
VERTICAL SYNC. SIGNAL: Same as above
Horizontal resolution 520 TV lines (NTSC 3.58 input)
RGB input signal 29-PIN CONNECTOR (INPUT 2):
RGB separate/composite sync/sync on green type analog input: 0–0.7 Vp-p, positive,75 Ω terminated
HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative) or composite sync (Apple only)
VERTICAL SYNC. SIGNAL: Same as above
Pixel clock 12–110 MHz
Vertical frequency 43–75 Hz
Horizontal frequency 15–70 kHz
Computer control signal 9-pin D-sub connector (RS-232C Port)
Rated voltage AC 100–240 V
Input current 2.1 A
Rated frequency 50/60 Hz
Power consumption 200 W
Heat dissipation 750 BTU/hour
Operating temperature 41°F to 95°F (+5°C to +35°C)
Storage temperature – 4°F to 140°F (– 20°C to +60°C)
Cabinet Plastic
I/R carrier frequency 38 kHz
Dimensions (approx.) 14 1⁄2” (W) x 6 9⁄16” (H) x 12 7⁄8” (D) (368 x 153.8 x 327 mm) (including swivel stand)
14 1⁄2” (W) x 4 5⁄8” (H) x 12 7⁄8” (D) (368 x 118 x 327 mm) (main body only)
Weight (approx.) 9.5 lbs. (4.3 kg) (including swivel stand)
8.4 lbs. (3.8kg) (main body only)
Supplied accessories Remote control, Two AA size batteries, Power cord (1.8 m), Terminal cover (XV-Z90U), Lens cap (attached
on the body), Lens cap strap, Operation manual, Screws for terminal cover (XV-Z90U)
Replacement parts Lamp unit (Lamp/cage module) (BQC-XVZ90+++1), Remote control (RRMCGA064WJSA:XV-Z90U,
RRMCGA088WJSA:DT-200), AA size batteries, Power cord (QACCDA007WJPZ), Terminal cover
(GCOVAA116WJKA:XV-Z90U), Lens cap (CCAPHA004WJ01), Lens cap strap (UBNDT0013CEZZ), Op-
eration manual (TiNS-A286WJZZ:XV-Z90U,TiNS-A287WJZZ:DT-200), Screws for terminal cover
(XBBSN40P10000:XV-Z90U)