Downloaded From Disc-Player.
Downloaded From Disc-Player.
SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 1.6 A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted.
SAFETY INFORMATION l Note: l This unit can be used only where the power supply is AC 220V-240V, 50/60Hz. It cannot be used l elsewhere. This player is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT is located on the rear cover. This product contains a low power laser device. To ensure continued safety do not remove any cover or attempt to gain access to the inside of the product. Refer all servicing to qualified personnel.
SAFETY INFORMATION Service Location and Handling l l l l l Do not attempt to service this Player yourself. Please refer any service to the nearest service centre approved by SHARP. Do not place your Player in enclosed space or do not cover it to prevent excessive temperatures inside the unit. Do not place the Player in direct sunlight, or near heat sources. Keep the Player away from magnetic fields, i.e. loudspeakers etc. Do not place any object containing water or other liquids on the Player.
INDEX PREFERENCES ....................................................... 20 SAFETY INFORMATION .................................................. 2 AUDIO ........................................................................... 20 SUBTITLE...................................................................... 20 INDEX................................................................................ 4 DISC MENU................................................................... 20 FEATURES...............
FEATURES < Compatible With DVD, VCD, Audio CD, and < Auto NTSC and PAL Video Disc Conversion MP3 Media Format. This DVD player can play a variety of disc media This unit can play NTSC and PAL formats discs. This including DVD Video, Video CD, Audio CD, and MP3 DVD player can automatically convert either format to media format. match your TV set.
PACKAGE CONTENTS Please verify that the following items are included within the DVD carton. If items are missing, please contact your retailer/supplier. < DVD Player x1 < Remote Control Unit x1 < AAA Batteries x2 < SCART Cable x1 < Operation Manual x1 Downloaded From Disc-Player.
PRECAUTIONS Please read the following carefully to get the best and safest performance from this DVD player < Power Supply < Usage and Storage ? Do not remove the top Make sure to use the correct power outlet as rated on the back of the DVD unit. (AC 220-240 V) cover to avoid possible electric shock from touching the inside of this unit. ? Do not place any heavy objects on top of this unit.
DISC CARE < Disc Usage ? Please hold all discs by their edges or the centre < Disc Cleaning ? Fingerprints or dirt on disc surfaces can weaken the opening as shown below. Do not touch the shiny light reflected from the disc and directly influence the surface of the discs. signal quality. The poorer the signal quality, the poorer the playback performance. Keep the disc clean by wiping it straight out from the centre with a dry soft cloth.
DISC COMPATIBILITY CHART This DVD player can play the following types of discs: Disc Type Dimension/Side/Layer Max. Playback Time (Storage Capacity) DVD Video DVD MPEG2 TYPE 12 cm (5’’) /single sided/single layer 12 cm (5’’) /single sided/double layer 12 cm (5’’) /double sided/single layer 12 cm (5’’) /double sided/double layer 133 min. (4.7 GB) 242 min. (8.5 GB) 266 min. (9.4 GB) 484 min.
REMOTE CONTROL UNIT To use the remote control unit to operate the DVD player, insert two batteries (size AAA) making sure that the + and – ends of the batteries are matched to the +/– marks printed inside the battery compartment. To use the remote controller, please point the remote control unit at the remote sensor on the DVD player. Notes: i Do not use different types of batteries together, or mix old and new batteries.
REMOTE CONTROL UNIT 1. OPEN/CLOSE 18. SKIP: Opens or closes disc tray. 2. Skips to the next chapter during playback. Refer to p.23. SETUP 19. STOP Customizes DVD player settings. Refer to p.16. 3. 4. 5. Stops playback. Refer to p.25. AUDIO During playback of a DVD disc with more than two audio languages, this button changes the audio language played. Refer to p.28. 20. DISPLAY ANGLE 21.
FRONT & REAR PANEL/DISPLAY WINDOW < Front Panel 1. 2. OPERATE Switch Button 8. Goes OPEN/CLOSE Button DVD/VCD/Audio CD. It functions as “Go to the previous page” in the Opens or closes the disc tray. 3. Disc Tray STOP Button 6. 7. PLAY Button the previous chapter/track during playback with 7REV Button Reverse scan. 10. Stops playback. 5. to PBC menu with VCD discs. 9. To place DVD, VCD, Audio CD, and MP3 discs on. 4. 9SKIP Button Turns the unit’s power on and off.
< Display Window 1. Disc inside indicator 6. DVD Indicator (See Fig. 4 below) ® 2. DTS Digital Audio Indicator (See Fig. 1 below) Identifies the inserted disc as a DVD disc. ® Indicates the disc played contains DTS Digital audio 7. PBC Indicator for VCD Disc (See Fig. 5 below) encoding. Playback Control indicator. 3. Title/Track Number Indicator 8. Some DVDs contain multiple title pages. This indicator displays the title number currently in use or track MP3 Indicator (See Fig.
CONNECTIONS < Video Output Terminals and Connections l Composite Video Output Terminal Composite video output is the most commonly used video connection in use today and is supported by most televisions and A/V receivers. Composite video is set to display without user setup. l S-Video Output Terminal You will want to use S-video output with televisions or monitors equipped with an S-video input whenever component video inputs are not available.
< Audio Output Terminals and Connections l Down-Mixed Audio Output Terminals (L/R) Use down-mixed (stereo) audio output terminals for ® connection with your television or other non-Dolby Digital A/V receivers or amplifiers. These terminals ® provide down-mixed Dolby Digital audio signals for standard 2-channel playback. l Coaxial Digital Audio Output Terminals Use digital audio outputs for connection with an ® ® external Dolby Digital or DTS decoder.
INITIAL SETTING Press the SETUP button on the remote controller to set up l TV TYPE the initial setting. The On-Screen Display (OSD) will display ? MULTI below: The DVD player will choose the correct system to display the playback of inserted disc. SETUP MENU - - MAIN PAGE ? TV SETUP AUDIO SETUP DOLBY DIGITAL SETUP AUDIO EFFECT SETUP LPCM SETUP GENERAL SETUP PREFERENCES EXIT SETUP NTSC The DVD player will output in NTSC format regardless of what format the disc was designed for.
< AUDIO SETUP There are two available items: They are AUDIO OUT and l DOWN MIX ? Pro Logic Please connect to a built-in Dolby Pro Logic receiver or DOWN MIX. l amplifier to enjoy the Dolby Pro Logic surround sound. AUDIO OUT ? You can choose to send the player’s audio signals to an Down mixed Stereo L/R audio output. external receiver using the following outputs: ? STEREO ANALOG: - - AUDIO SETUP PAGE - - Audio signals are sent using stereo (L/R) audio AUDIO OUT DOWNMIX terminals.
l DYNAMIC “Dynamic Range” is the difference between the maximum level and the minimum level of sounds. Sounds on a movie originally designed for movie < LINEAR PCM SETUP This option sets the audio output format sent using the unit’s coaxial digital audio output. theaters feature a very wide dynamic range, so sometimes it is not suitable for home use.
l < GENERAL SETUP There are four available selections: ANGLE MARK, OSD encoding text into an NTSC television signal. A TV can LANG, CAPTIONS, and SCR SAVER. display the text with a built-in decoder. Closed Caption ANGLE MARK l can be carried on DVD. If a DVD title contains a CC During playback of a title with multiple angle sections, the message " mark on the rear of the box, then you can set Captions " will appear on the upper corner of to “ON” and read written captions on the TV screen.
l < PREFERENCES DISC MENU This unit supports six DISC MENU languages. Preferences allow you to set the default AUDIO, SUBTITLE, DISC MENU, PARENTAL, PASSWORD, and factory DEFAULTS of this player. This setting is only available - - PREFERENCES PAGE - - when the DVD player is in the STOP mode by pressing the STOP AUDIO SUBTITLE DISC MENU PARENTAL PASSWORD DEFAULTS button twice. NOTES i Pressing the press the l STOP STOP button once only pause the playback.
l PASSWORD The password is a 4-digit number. When you want to change the password, select “CHANGE” as shown below. - - PREFERENCES PAGE - AUDIO SUBTITLE DISC MENU PARENTAL PASSWORD DEFAULTS CHANGE MAIN PAGE CHANGE PASSWORD You will be asked to enter the old password, then enter the new password, and confirm it. PASSWORD CHANGE PAGE OLD PASSWORD: NEW PASSWORD: CONFIRM PWD: PLEASE ENTER OLD PASSWORD NOTES: i l The default password number is”3308”.
ON-SCREEN DISPLAY (OSD) < DVD OSD Modes < Audio CD/VCD OSD Modes There are two OSD display modes available when playing There are two OSD display modes available when playing a DVD disc. a VCD, and Audio CD disc. l l Mode 1 Mode 1 Shows the status of the pressed button and some special Shows the status of the pressed button and some special messages are displayed on the screen.
BASIC OPERATION OF PLAYBACK Preparation: ? If a television set is used, turn on its power and select the appropriate input AV, S-Video or SCART. If the SCART connection is used then the TV will switch to the correct input when the DVD player is turned on. ? If a sound system is used, turn on the amplifier first and make sure its outputs are set properly. PLAYING VCD PBC MENU < START Playback 1. 2. 3. Press the OPERATE button to turn on the DVD player.
< FAST FORWARD/REVERSE SCAN < SLOW-MOTION Playback Using the FWD8 and 7REV buttons to fast forward and l DVD Playback reverse scan. ? When the SLOW button is pressed, the speed of playback changes in cycles of slow forward l DVD Playback ? When the FWD8 or 7REV button is pressed, the 4à 8 and then slow reverse 2à 2à 4à 8.
Note: < STOP Playback l i DVD Playback Some function keys will be differed from its original definition even cease to function in some discs. The main cause is those specific Pressing the STOP button once pre-stops (pauses) discs were already contained its operation function in process of playback. You must press the STOP button twice to totally manufacturing. In this case, to operate the function key, please follow stop the playback. on-screen indication for operation.
ADVANCED OPERATION OF PLAYBACK < REPEATED Playback < PROGRAM Playback TITLE/CHAPTER Repeat l Here the program playback function is only available for When the REPEAT button is pressed, the repeated Audio CD, or a VCD with PBC off. playback is triggered and the OSD message is l Track Program changed in cycles of “CHAPTER REPEAT ON”, 1. Press the PROGRAM button to program the tracks for “TITLE REPEAT ON”, and “REPEAT OFF.” ? program playback during STOP status.
< TITLE MENU (DVD Only) < MULTI-ANGLE Playback Some DVD discs have a title menu recorded within them to Some DVD discs may contain scenes with a number of use for selecting titles for play. This feature will only work different angle views. Whenever a scene with multiple with these discs. angle views is played, you can use the ANGLE button to ? Press the TITLE button during playback to reach the view this scene from different angles. title menu.
< Changing SUBTITLE During Playback English Language During playback of a DVD disc with more than two subtitle AUDIO 01 / 02: ENGLISH Chinese Language AUDIO 02 / 02: CHINESE languages, you can change the subtitle or disable the subtitle by pressing the SUBTITLE button. ? When the SUBTITLE button is pressed, the subtitle for playback will change in cycles among the available subtitle numbers and “OFF” status. “ OFF” will disable the subtitle display.
? To search by chapter, use the 3 4 5 6 buttons to highlight the first two digits of the “CHAPTER nn/nn” section. Once highlighted, use the number keys on the remote to enter the chapter you want to play. Presses ENT/PLAY to complete your search selection. ? < VCD PLAYBACK CONTROL (PBC) This function is only available for Video-CD version 2.0 or higher. The PBC operation may differ by disc, therefore, refer to the instructions for each disc.
MP3 PLAYBACK < MP3 Compatible Format ? During MP3 playback, please select PAL TV system in 4. Please use 3 4 5 6 arrow buttons for movement to select a track (song) and press ENT/PLAY button to play. the setup menu. ? This unit supports 32~320 KBPS bit rate MP3 files l MP3 Root Menu that are formatted by CD-ROM ISO9660 Data format. ? During playback, for entering the root menu of the ? The file name can be showed in maximum 8 letters.
l Skip Playback ? Under the status of playback, you can use the SKIP: and 9SKIP buttons to skip forward and reverse playback. : MP3 TITLE 01 PAGE 01/06 SONG 01 SONG 03 SONG 05 SONG 07 SONG 09 SONG 11 4 SONG 02 SONG 04 SONG 06 SONG 08 SONG 10 SONG 12 l Pause Playback ? Pressing the STILL/PAUSE button during playback will pause the playback.
ADDITIONAL INFORMATION < GLOSSARY l < REGION MANAGEMENT INFORMATION ® DTS This DVD player is designed and manufactured to respond ® l l ® DTS stands for Digital Theater System. DTS Digital to the Region Management Information recorded on a DVD Surround is an encoded/decoded system, which disc. If the region number described on the DVD disc does delivers 5.1 channels of “master quality” 48KHz/20-bit not correspond to the region number of this DVD player audio sound.
< TROUBLE SHOOTING Before requesting service for this unit, please check the following chart for possible causes and remedies. If the remedies indicated in the chart below do not solve the problem, please consult your dealer for instructions.
< SPECIFICATION Power requirement AC 220-240 V, 50 Hz Power consumption <20 W (approx. 5W at standby mode) Weight 3.5Kg Dimensions (W x D x H) 430x310x80 (mm) Operating temperature range +5 °C to +40 °C Operating humidity range 5 % to 90 % (no condensation) Video system PAL 625/50 Hz , NTSC 525/60Hz S-video terminal Y output level 1 Vp-p (75 Ω) C output level 0.