Operation Manual

SETTING UP

Using the Battery Pack

CAUTION

• Use only SHARP model “BT-L300S” battery pack with this Player.

Use of another battery may present a risk of fire or explosion.

To install a battery pack in the Player

1 Make sure that the Player is turned off and then unplug the DC cord.

2 To open the battery pack compartment cover, while pressing at the

mark, slide the cover forwards (1), and raise it upwards (2).

3 Slide the battery pack into Player’s battery pack compartment in the

direction indicated by the arrow as far as it locks firmly with a click.

4 Slide the battery pack compartment cover along the ridges of the battery

pack at about 45° until the two tabs of the cover are at their original location

(1), and lower the cover to close it (2).

CAUTION

• When turning off the power, while using the battery pack, make sure to slide

the Player’s OPERATE switch to “OFF”.