Service manual

4 MAINTENANCE
16
4 MAINTENANCE
4.1 GENERAL _______________________________________________________________________________
1. Adjustment and maintenance should always be performed by a
qualified technician. If proper adjustments cannot be made,
contact an Authorized Jacobsen Dealer.
2. Inspect the equipment on a regular basis, establish a
maintenance schedule and keep detailed records.
a. Keep the equipment clean.
b. Keep all moving parts properly adjusted and lubricated.
c. Replace worn or damaged parts before operating the
machine.
d. Keep all fluids at their proper levels.
e. Keep shields in place and all hardware securely fastened.
f. Keep tires properly inflated.
3. Long hair, jewelry, or loose fitting clothing may get tangled in
moving parts.
4. Use the illustrations in the Parts Catalog as reference for the
disassembly and reassembly of components.
5. Recycle or dispose of all hazardous materials (batteries, fuel,
lubricants, anti-freeze, etc.) according to local, state, or federal
regulations.
4.2 INSPECTING BLADES _____________________________________________________________________
1. Every 50 hours of operation or whenever blades are removed
from mower, carefully examine the blades to make sure they are
in good operating condition. Blades showing any bends (G),
grooves (H) or cracks (J) must be replaced.
2. Any of the above conditions can cause a piece of the blade to
break away and be thrown from the mower causing very
serious injury to bystanders or property damage.
3. A bent blade could have a microscopic crack (G) that can grow
and allow a piece of the blade to break. Bent blades will also
create vibration and other stress on the machinery.
4. Dust or sand particles can wear a dangerous groove in the
blade (H) between the air vanes and the flat portion of the
blade that will rapidly grow and produce a crack (J) permitting a
piece of the vane to break off.
Figure 4A
WARNING
Before you clean, adjust, or repair this equipment, disengage all
drives, lower implements to the ground, engage parking brake,
stop engine, and remove key from ignition switch to prevent
injuries.
Make sure the mower is parked on a solid and level surface.
Never work on a mower that is supported only by the jack. Always
use jack stands.
!
CAUTION
Use care when checking blades to avoid pinching hands and
fingers between blade ends.
WARNING
Never attempt to straighten, weld, or repair a damaged blade.
Always replace a damaged blade.
!
!
HR025
G
H
J
HR025