User`s guide

SOCKETS TCP/IP Stack 121
E-EQ-MX1RG-D MX1 Reference Guide
Setting SOCKETS.CFG Parameters
Set IP Address
To enable DHCP set the IP address to 0.0.0.1
IP address XXX.XXX.XXX.XXX/16
where
XXX.XXX.XXX.XXX is the IP address
16 indicates the number of bits in the network ID
Set ARP INIT
Controls whether a DHCP ARP is sent when booting up.
ARP INIT GRAT
Using this option makes the stack behave the same as before. The stack does not send a DHCP
ARP when booting up (In this mode, the ARP contains the MAC and IP addresses in the sender’s
field). This option is the default.
ARP INIT DHCP
Using this option sends a DHCP ARP on boot up (the sender’s IP address field is zero filled).
Set Interface
For all radios except Symbol DS 11MB
Interface sets the physical interfaces
Interface pdr if0 dix 1500 10 0x69
where
pdr = packet driver
if0 = interface_card
dix = frame type
1500 = MTU
10 = Buffers
0x69 = ioaddr
For Symbol DS 11MB radios
Interface sets the physical interfaces
Interface pdr if0 dix 1400 10 0x69
where
pdr = packet driver
if0 = interface_card
dix = frame type
1400 = MTU
10 = Buffers
0x69 = ioaddr