User`s guide

Endcaps 17
E-EQ-MX1RG-D MX1 Reference Guide
Endcap Removal and Installation
When removing or installing the endcaps, protect the MX1 internal components and these
particular accessories from electrostatic discharge.
All MX1 endcaps are installed similarly.
The software that controls the endcap will vary so endcap types are not considered easily
interchangeable.
After installation of an endcap is complete, use the endcap for its intended function. If the
operation is unsuccessful or erratic, remove and reinstall the ribbon connector – the Zero Insertion
Force (ZIF) connector.
There are four types of scanner endcaps. All four are installed on the MX1 in the same way –
1. carefully place rubber o-ring gasket
1
on the endcap,
2. attach ZIF cable,
3. snap the endcap onto the MX1,
4. screw the endcap to the MX1, torquing the screws to no more than 3 in/lb. (.34 N/m).
ZIF Connector
All MX1 endcaps use ZIF connectors to maintain permanent connection between the endcap and
the MX1.
The Zero Insertion Force (ZIF) Connector is a way to electronically connect devices without using
excessive force during the installation of cables. Excessive force can cause bent connector pins or
misaligned and/or damaged cables.
• Caution must be exercised when handling the endcaps. The electrical connectors are
delicate and may damage easily.
• The ZIF connector is on the right hand side inside the cap when the MX1 is face up.
Preparation
1. If a handle is installed, remove it at this time.
2. Caution must be exercised when handling the endcaps. The electrical connectors are delicate
and may damage easily.
3. Caution must be exercised when handling o-ring gaskets as they are delicate and may break if
stretched.
4. Carefully align the o-ring to the endcap before reattaching the endcap.
1
The o-ring is directional and must be placed right side up on the endcap seal.