Operation Manual

37
www.sharp.co.uk/support
VCR Setup
/
OPEN/
CLOSE
OPERATE
VCR/ DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
VIDEO Plus+
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ANGLE
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
PLAY
STOP
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
RRMCGA069WJSA
OPEN/CLOSE
OPERATE
EJECT/STOP
REW
PLAY/X2
REC
CH
VCR/DVD
SELECTOR
TIMER
VCR DVD
PLAY
STOP
LINE IN 3 VIDEO L - AUDIO - R
/
DV-NC65
DVD / CD PLAYER
PAL
OPERATE
EJECT /
STOP
Decoder Switching Operation
If you have a separate decoder connected to the Unit’s L2 input as
previously shown in the “Basic Connection” section, you will need to
set the decoder function to ON in order to record the unscrambled
signal and/or watch it on your TV. Now, when the Unit receives a
scrambled signal it is output via LINE 2 terminal to the decoder. The
decoder then outputs the unscrambled signal back to LINE 2
terminal and the signal can be recorded. The Unit outputs the
descrambled signal to your TV through the LINE 1 terminal and you
can watch the unscrambled picture.
When making recording using a separate decoder connected as
shown, remember to leave the decoder function ON.
If you connect a decoder unit to this Unit, the decoder unit provides
a switching signal which will automatically allow your TV to display
the unscrambled signal routed through the Unit. To use this feature
make sure that the Unit is connected to both TV and decoder unit by
the SCART leads. Then:
• Press OPERATE to place the Unit in STAND-BY mode.
OR
• Press TV/VCR to place the Unit in “VCR mode”. The “VCR”
indicator appears on the VCR Front Panel display.
Selecting the Output From the VCR
If your VCR is connected to your TV with a scart lead, when you start
to play a video tape the VCR will automatically switch its output so
that the playback picture is shown on the TV. In this case, “VCR” will
appear on the VCR display.
You can manually override this by pressing TV/VCR on the remote
control. Now the TV broadcast channel will be seen on the TV screen
and “VCR” will disappear from the VCR display.
• Pressing TV/VCR again will return the TV picture to the playback
picture.
• While in DVD mode, the unit will override this function.
DVNC65H028_038.pm6 30/8/02, 11:34 am37