Operation Manual

www.sharp.co.uk/support
45
DVD Setup
AUDIO Setting
COMPRESSION ............ Use this setting for increasing the average
volume of Dolby Digital audio when playing a
DVD.
DIGITAL/MPEG ....... Use these settings for specifying the type of
digital output when playing a disc recorded
using Dolby Digital/MPEG AUDIO.
CINEMA VOICE............. Use the setting for raising the sound of the
centre speaker to make the voices in a
movie easier to hear.
Setting the COMPRESSION
(Dolby Digital output level)
When Dolby Digital is used to record the audio on a DVD disc, the
average overall volume level of the audio is relatively lower than that
produced by an Audio CD. This is to provide the widest possible
dynamic range. To counteract this, this Unit automatically raises the
overall average volume level of a disc recorded using Dolby Digital to a
level that is similar to that of an Audio CD.
• OFF.............. Audio level recorded on disc is played back without
modification.
• ON ............... Dolby Digital average audio level is increased so it
sounds similar to that of Audio CD.
• Use of the “OFF” setting is recommended when the Unit is connected
to audio equipment or, depending on the disc, the sound is abnormal.
• Advanced Surround is disabled when “COMPRESSION” is set to
“ON”.
Preparation
• Press OPERATE. Then move the VCR/DVD CHANGE Switch to
DVD.
1 Press DVD SETUP to display the SETUP screen.
/
OPEN/
CLOSE
OPERATE
VCR/ DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
VIDEO Plus+
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ANGLE
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
PLAY
STOP
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
RRMCGA069WJSA
COMPRESSION:
OFF
DVD
Dolby Digital Audio
Audio CD's
• Low audio level
• Audio level the same
as audio CD, etc.
COMPRESSION:
ON
DVNC65H043_048.pm6 30/8/02, 11:39 am45