Operation Manual

www.sharp.co.uk/support
47
DVD Setup
3 Use ' or " to select “BITSTREAM” or “D-PCM”.
BITSTREAM: Use this setting for a digital connection of a receiver
(amplifier) equipped with a Dolby Digital decoder.
D-PCM: Use this setting for a digital connection to the
(Down Mix PCM) PCM digital input jack of a DAT or MD, or for a digital
connection to a receiver (amplifier) that does not have
a Dolby Digital decoder.
4 Press ENTER to confirm the setting.
5 Press RETURN to exit the SETUP screen and return to normal
screen.
• When you have completed the above setting, press RETURN to exit
the SETUP screen. However, if you want to specify the “MPEG”
setting in succession, proceed to step 1 below.
Setting the MPEG
Selected the same as “COMPRESSION” on page 45 for MPEG signals.
1 Press ENTER and then use ' or " to select “MPEG”.
2 Press ENTER to display the settings you can select.
3 Use ' or " to select “BITSTREAM” or “PCM”.
BITSTREAM: Use this setting for a digital connection of a receiver
(amplifier) equipped with an MPEG Audio decoder.
PCM: Use this setting for a digital connection to the PCM
digital input jack of a DAT or MD, or for a digital
connection to a receiver (amplifier) that does not have
an MPEG Audio decoder.
4 Press ENTER to confirm the setting.
5 Press RETURN to exit the SETUP screen and return to normal
screen.
• If you want to go on and specify other settings, use ' or " to
display the other SETUP screen without pressing RETURN.
When playing a disc recorded using DTS, the bitstream type signal is
output regardless of the setting of “ Digital” and “MPEG”.
/
OPEN/
CLOSE
OPERATE
VCR/ DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
VIDEO Plus+
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ANGLE
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
PLAY
STOP
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
RRMCGA069WJSA
AUDIO
BITSTREAM
PCM
MPEG
• When audio CD’s that support MPEG are played back, BITSTREAM signals will be output, even if
“MPEG” has been set to “PCM”.
• Make sure to set “DIGITAL” or “MPEG” to “PCM” when making a digital connection to 2 channel audio equipment or
MD. Leaving on “BITSTREAM” may cause static noise and damage the speakers as well as incorrect recording on
MD’s.
DVNC65H043_048.pm6 30/8/02, 11:39 am47