Operation Manual

97www.sharp.co.uk/support
■ DVD
Problem
• The DVD player is switched on but
does not operate.
• The playback image does not
appear.
• No sound is produced.
• The sound is not Dolby Digital (5ch
or 5.1ch).
• The image and sound are garbled.
• The sound is not stable during
playback.
Suggested Solution
• Have you loaded a disc?
• Is the disc unplayable? (See pages 9 – 11.)
• Is there dew in the DVD player? (See page 11.)
• Are the video and audio cables connected correctly? (See pages
18 – 23.)
• Is the disc scratched? (See page 11.)
• Is the disc dirty? (See page 11.)
• Is the disc loaded upside down?
• Is the input selector on the TV set to “VIDEO” or “AV”?
• Is the audio equipment switched on and are all the components
connected properly? (Refer to the operation manuals for your
audio equipment.)
• Is the disc you are playing recorded in Dolby Digital (5ch or
5.1ch)?
• Have you set the “ DIGITAL” in “AUDIO SETUP” to
“BITSTREAM”? (See page 45.)
• Is the disc scratched? (See page 11.)
• Are vibrations from the speakers affecting the DVD player?
• Set the “COMPRESSION” in “AUDIO SETUP” to “OFF” (See page
45.)
This unit is equipped with a microprocessor. Its performance could be adversely affected by external electrical
noise or interference. If this should happen, unplug the Unit and plug it in again after a few minutes.
Troubleshooting
Possible Cause/Solutions
• The record-protection tab has been removed from the cassette.
• Broadcast does not carry VPS/PDC signal which alters recording
time.
• Check VPS/PDC mode is switched ON.
• Ensure date and time are correctly set on the Unit.
• Make sure there is no other tape in the VCR.
• Make sure you are loading the tape correctly.
• Make sure the tape is not at the start.
• The channel position has been set to be skipped. Cancel the SKIP
mode for that channel.
• Make sure all the cables are connected properly.
• Make sure the VCR power cord is properly plugged in.
• Possible weak signal strength, the same channel with a better
signal strength may have been tuned in on another VCR preset
channel. Example; VCR preset 1 = BBC1 and VCR preset 14 =
BBC1 (Refer to Manually Sorting Channels section to move the
channel to your desired position.)
• TV aerial may need adjusting.
Problem
• Tape is automatically ejected when
pressing
ÆÆ
ÆÆ
ÆREC or TIMER ON/OFF.
• VIDEO Plus+ does not record
desired programme.
• Tape can not be loaded.
• Rewind is not possible.
• Desired channel position can not be
selected.
• No colour or poor TV picture on
normal viewing.
• Desired channel has interference.
OTHER
INFORMATION
DVNC65H096_101.pm6 30/8/02, 12:11 pm97