Specifications

13
Summary: Jumpers setting
Ref Purpose Note
JA1 On board +5V logic power enable 1-2 & 3-4 closed, factory set, do not remove
JA2 On board +3.3V logic power enable 1-2 & 3-4 closed, factory set, do not remove
JA3 Panel power voltage select
CAUTION: Incorrect setting can damage
panel
See panel voltage setting table 1
JA5 Panel power voltage select
CAUTION: Incorrect setting will cause panel
damage
See panel voltage setting table 1
JA6 Panel power voltage select
CAUTION: Incorrect setting will cause panel
damage
See panel voltage setting table 1
JB1 Backlight brightness voltage range 1-2 closed = 3.3V max
2-3 closed = 5V max
JB2 Backlight inverter on/off control – signal level 2-3 = On/Off control signal ‘High’ = +5V
1-2 = On/Off control signal ‘High’ = +3.3V
Open = On/Off control signal ‘High’ = Open collector
CAUTION: Incorrect setting can damage inverter.
JB3 Backlight inverter on/off control – polarity 1-2 = control signal ‘high’ = CCFT ON
2-3 = control signal ‘low’ = CCFT ON
JB5 Backlight control type selection 1-2 = VR/Digital switch mount control
3-4 = Analog backlight brightness - voltage range 0~5V
5-6 = PWM (Pulse Width Modulation) brightness
JC1– JC16 Reserved for custom configuration Reserved
JP2 Reserved Reserved
JP4 Custom configuration 1-2 = Reserved
3-4 = On-board programming
5-6 = Display “Blue only” function on OSD menu
JP6 Input power control Short = External switch control
Open = Switch mount control
JT1 Composite video-in terminator enable Open = composite video input is not terminated
Close = composite video input is terminated with 75Ω
JT2 S-Video luma-in terminator enable Open = S-video luma input is not terminated
Close = S-video luma input is terminated with 75Ω
JT3 S-Video chroma-in terminator enable Open = S-video chroma input is not terminated
Close = S-video chroma input is terminated with 75Ω
JT4 Component luma-in terminator enable Open = component luma input is not terminated
Close = component luma input is terminated with 75Ω
JT5 Component Cr-in terminator enable Open = component Cr input is not terminated
Close = component Cr input is terminated with 75Ω
JT6 Component Cb-in terminator enable Open = component Cb input is not terminated
Close = component Cb input is terminated with 75Ω
JT7 Composite video 2-in terminator enable Open = composite video input is not terminated
Close = composite video input is terminated with 75Ω
JT8 Reserved Reserved
S1 & S2 LVDS or TTL panel selection LVDS panel : All OFF
TTL panel : All ON
SW3 Panel & function selection See table 2
SW4 Panel & function selection See table 3