Instruction manual

SR84 / SR85, CH33

(E) 3

• The slider holders are used to secure the slider in place during transport. They are not guides for installa-

tion.

• Do not take off the slider holders, if possible, until immediately before securing the slider.

• Even if the slider holders are removed, the plastic hook provided on the slider allows the slider to

maintain an approximate positional relationship with the scale unit.

• The plastic hook can come off if the slider is forcibly twisted or other excessive force is applied. If the

plastic hook comes off, return the plastic hook back to its original position before performing the

installation.

Fig. 2-3

• Before installing the scale, check that the alignment of the installation surface (or installation brackets) is

within the standards.

• Use a scale installation bracket, where applicable, having a length covering the entire scale length. Even

when using divided brackets, be sure to always check that the alignment of the installation brackets is

within the standards.

• The rear surface of the scale unit is used as the installation guide.

• Loosely turn the mounting screws first. Determine the alignment and then tighten the screws to fasten the

scale. (See Fig. 2-4)

Fig. 2-4

Slider holder L

State when Transporting / Securing in Place

Slider holder R

Lever

(Turn to this position)

Lever

(Turn to this position)

Step 2

Step 1

Plastic hook

Removing the slider holder

1. Removing the lock

Turn the right and left slider holder levers in the

counterclockwise direction (position in the illustration).

2. Removing

Slide the slider holder to the outside, and remove from

the scale.

Scale : M6 ✕ 35 (9 N

•

Slider : M4 ✕ 20 (2.7 N

•

Bring into contact