User Manual

86 EN
Symptom Remedy
Others
The unit does not operate
correctly.
• If static electricity or anything else causes the unit to operate abnormally,
unplug the mains cable and plug it in again.
The disc tray does not open
when you press
[OPEN/CLOSE A].
• It may take a few seconds for the disc tray to open after you have recorded
or edited a disc.
• This is because the unit is sending data to the disc.
“Repairing” appears on the
display.
Repairing
• If a power failure occurs or the mains cable is unplugged during recording,
finalising, formatting or editing (even after “Wait for a moment.” message
disappeared), a repairing process will begin automatically when the unit is
turned on next time. It may take several minutes up to about four hours.
In a case you intend to cancel
the Repairing process.
• If you intend to cancel the Repairing process, press [OPEN/CLOSE A] on the
front panel, then select “Yes” with [Cursor s / B] and press [ENTER]. After
that, the disc tray will automatically open. In case the Repairing process is
cancelled, the disc MAY NOT work.
Repairing
Do you want to cancel a repairing process ?
When selecting “Yes”, the disc may not be
usable.
Yes No
Others
Troubleshooting (cont’d)
* If the above remedies do not solve the problem, please call an authorised service centre.