Owner's Manual

6-27
SYSTEM SETTINGS
Contents
OPERATION PANEL (ADMINISTRATOR)
Operation Settings
Settings related to machine operation can be configured. Select the [Operation Settings] key to configure the settings.
Other Settings
Keys Touch Sound
This setting is used to adjust (or turn off) the volume of
the beep that sounds when you select a key.
Display Language Setting
The language that appears in the display can be
changed.
MFP Display Pattern Setting
One of the six color patterns can be selected for the color pattern in the display.
A sample of the selected pattern can be viewed.
Device Control
These settings control devices installed on the machine. Select the [Device Control] key to configure the settings.
Other Settings
Registration Adjustment
If the colors are out of place on the printed surface when
color printing is performed, the print positions of the
colors can be adjusted.
To perform this adjustment, select the [Auto Adjustment]
key. A message will appear. select the [Execute] key.
Fusing Cleaning Mode
Use this function to clean the machine's fusing unit when
dots or other dirt appear on the printed side of the paper.
When this function is executed, a "V" is printed on both
sides of the paper and the fusing unit is cleaned.
Optimization of a Hard Disk
This function optimizes the hard drive of the machine by
defragmenting data. If a job is in progress, a message
will appear and optimization will not begin until the job is
finished. During optimization, the following operations
are not possible:
• Web page access, reception of print data
• Use of keys on the operation panel
• Turning off the power with the main power switch of
the machine.
• Auto Power Shut-Off
When optimization is completed, the machine will
automatically restart.
When user authentication is enabled and a display
language is specified in the favorite operation group,
that setting is given priority.
• When "Disabling of Duplex" in web page is enabled
(page 6-72), printing only takes place on one side of
the cleaning sheet.
• If improvement is not noticed after the first time you
use the function, try executing the function again.
• It is not possible to move to the job status screen
while this function is operating.
When the print hold (retention) function is frequently
used and output of files seems somewhat slow,
optimizing the hard drive may improve performance.