Specifications

c.
Optical drive (see
Optical drive on page 38)
d. Keyboard (see
Keyboard on page 47)
Remove the base enclosure:
1. Remove the Torx8 TM2.5×9.0 screw that secures the base enclosure to the computer.
2. Close the computer.
3. Turn the computer upside down, with the rear panel toward you.
4. Remove the following:
●
Four Torx8 TM2.5×9.0 screws (1) from the computer rear panel
●
Two rubber screw covers (2) (available in the Rubber Kit, spare part number 639483-001)
●
Two Torx8 TM2.5×9.0 screws (3) from the surface of the base enclosure
●
Three Phillips PM2.0×3.0 (4) screws from the battery bay
Component replacement procedures
53