Operation Manual, User's Manual
Table Of Contents
7-11
SETTING MODE►SETTING MODE LIST
*1 When an inner finisher/finisher/finisher (large stacker)/saddle stitch finisher/saddle stitch finisher (large stacker) is installed.
*2 When an inner finisher/finisher/finisher (large stacker)/saddle stitch finisher/saddle stitch finisher (large stacker) is installed and a
punch module is installed.
*3 When a saddle stitch finisher/saddle stitch finisher (large stacker) is installed.
*4 When a saddle stitch finisher (large stacker) is installed.
Printer Settings
U: General user; A: System administrator/Administrator
Text /Image Printing
Text Settings (Stamp) – No Yes 2-95
Custom Stamp – No Yes 2-98
Custom Watermark – No Yes 2-98
Setup Items
Factory default setting
U A Page
● Printer Settings
Condition Settings
Prohibit Notice Page Printing Enabled No Yes 3-3
Prohibit Test Page Printing Disabled No Yes 7-59
A4/Letter Size Auto Change Disabled No Yes
3-7
Print A3W (12x18) and 11x17 on A3 Size Paper Disabled No Yes
Bypass Tray Settings No Yes
• Enable Detected Paper Size in Bypass Tray Disabled No Yes
• Enable Selected Paper Type in Bypass Tray Disabled No Yes
• Exclude Bypass-Tray from Auto Paper Select Disabled No Yes
Job Spool Queuing Enabled No Yes B
Disabling of USB Memory Direct Print Disabled No Yes 3-79
Disabling of Network Folder Direct Print Disabled No Yes 3-80
Disabling sending while printing Disabled No Yes 3-76
Interface Settings No Yes
7-61
Hexadecimal Dump Mode Disabled No Yes
I/O Timeout 60sec. No Yes
Enable Network Port Enabled No Yes
Network Port Emulation Switching Auto No Yes
Port Switching Method Switch at End of Job No Yes
Setup Items
Factory default setting
U A Page