Operation Manual

12
E
Connecting Peripheral Equipment
Connection when the PN-ZB01
(optional) is attached
The PN-ZB01 expansion board (optional) allows the use of
additional connection terminals.
6. PC/AV DVI-D input terminal
Set DVI of INPUT SELECT on the OPTION menu
according to the device to be connected.
Select the audio input terminal to be used in PC DVI-D or
AV DVI-D of AUDIO SELECT on the OPTION menu.
7. PC RGB input terminals
Set BNC of INPUT SELECT on the OPTION menu to PC
RGB when using the PC RGB input terminals.
Select the audio input terminal to be used in PC RGB of
AUDIO SELECT on the OPTION menu.
8. AV component input terminals
Set BNC of INPUT SELECT on the OPTION menu to
AV COMPONENT when using the AV component input
terminals.
Select the audio input terminal to be used in AV
COMPONENT of AUDIO SELECT on the OPTION menu.
Cannot be used when D-SUB in INPUT SELECT on the
OPTION menu is set to AV COMPONENT.
9. AV video input terminal
Select the audio input terminal to be used in AV VIDEO of
AUDIO SELECT on the OPTION menu.
Cannot be used when D-SUB in INPUT SELECT on the
OPTION menu is set to AV VIDEO.
10. AV S-video input terminal
Select the audio input terminal to be used in AV S-VIDEO
of AUDIO SELECT on the OPTION menu.
11. Audio1 input terminals / Audio2 input terminals
Set the audio input terminal to be used in each input
mode in AUDIO SELECT on the OPTION menu.
12. LAN terminal
You can control the monitor from a PC on a network by
connecting a commercially available LAN cable between
this terminal and a network.
13. External speaker terminals
To use external speakers, set SPEAKER SELECT on the
SETUP menu to EXTERNAL.
Be sure to use external speakers with an impedance of 6 Ω
or greater and a rated input of at least 7 W.
132
Approx.
3-15/16 inch
(10 cm)
1. Attach a speaker cable core (included with the PN-ZB01) to
the end of the speaker cable connected to the monitor.
2. While pushing the tab, insert the tip of the cable.
3. Release the tab.
TIPS
Be sure to connect the + and - terminals and the left and
right speakers properly.
Avoid short circuiting the + and - terminals.
When SPEAKER SELECT is set to EXTERNAL, the
internal speakers are disabled.
14. PC/AV DVI-D output terminal
The video of the PC/AV DVI-D input can be output to an
external device.
Outputting HDCP-encrypted video requires an external
device which supports HDCP.
This terminal allows the daisy chain connection of up to 5
monitors.
TIPS
The length of the signal cables or surrounding environment
may affect the image quality.
The screen may not display properly when using terminals
other than PC DVI-D/AV DVI-D for the input mode. In this
case, turn off the power to all the monitors connected in a
daisy chain and then turn the power on again.
When connecting monitors in a daisy chain set AUTO
INPUT CHANGE to OFF.
Video output is disabled in the following cases:
When the power is turned off
When the monitor is in input signal waiting mode