Specifications

8
●
Do not discard the battery pack with normal
garbage or place in fire.
●
Keep the battery pack out of the reach of children.
●
Use the battery pack properly following the
indicated specifications.
WARNING
This machine is not water proof.
Use the machine following the description below.
●
Immediately wipe the electric drill or the machine
when any liquid such as cutting fluid or water is
applied.
●
Do not operate with wet hand.
●
Do not use in rain.
CAUTION
●
Do not force feed the cutter while driling
manually.
Jetbroach and Hi-Broach cutters use a reduced wall
thickness to minimize cutting resistance, resulting in
faster hole productivity and less shavings. Pressure
required to feed a Jetbroach or Hi-Broach cutter
is far less than that of a twist drill bit; if too much
pressure is applied to the cutter, life and or breakage
may result.
●
The color of LED changes according to the load
of the electric drill. Use it with LED in green or
yellow.
LED turns green or yellow when the load of the
electric drill is in normal condition and turns or blinks
in red when it is in overload condition. Decrease
the feeding rate of the drill when LED is turned or
blinking in red since the electric drill is in overload
condition and obtain a load with LED in green or
yellow when drilling.
●
The power of the electric drill drops when
excessive load is applied to the electric drill
and LED starts blinking rapidly in red. When
load is applied continuously, the machine will
automatically stop and LED will start blinking in
white.
When further load is applied to the electric drill even
when LED is turned or blinking in red, the power
of the electric drill drops to protect the electric drill
and battery pack. The electric drill returns to normal
operation when the load is decreased before it stops
automatically due to overload. If the electric drill
stops automatically, turn the switch off and then turn
the switch back on to continue the operation.
●
Store the machine by keeping the electric drill at
lowered position when not in use.
The machine may fall when stored with the electric
drill at a lifted position.
●
When energized, the magnet may exhibit a
buzzing sound or a slight hum.