Operation Manual

173

In Case of Power Failure

When power is lost, the register retains its memory contents and all information on sales entries.

• When power failure is encountered in register idle state or during an entry, the register returns to the

normal state of operation after power recovery.

• When power failure is encountered during a printing cycle, the register carries out the correct printing

procedure after power recovery.

In Case of Printer Error

If the printer runs out of paper, the printer will stall, and “PAPER EMPTY” will appear on the display. Key

entries will not be accepted. Referring to “Installing and Removing the Paper Roll” in this chapter, install a

new paper roll in the proper position, then press the

key. The printer will print the power failure symbol

and resume printing.

If the print roller arm comes up, the printer stalls, and “HEAD UP” will appear on the display. Key entries will

not be accepted. Push down the arm until it is securely locked, then press the

key. The printer will print

the power failure symbol and resume printing.

Cautions in Handling the Printer and Recording Paper

■ Cautions in handling the printer

• Avoid the following environments:

Dusty and humid places

Direct sunlight

Iron powder (A permanent magnet and electromagnet are used in this machine.)

• Never pull the paper when the print roller arm is locked. First lift up the arm, and then remove the paper.

• Never touch the surface of the print head and print roller.

Operator Maintenance

ER-A280F_N(SEEG)(E)-9 09.6.18 6:56 AM Page 173