Operation Manual

Manager Mode
The manager mode is used when managerial decisions must be made concerning register
entries, for example, for overriding limitations and for other various non-programming managerial
tasks.
Normal register operations may also be performed in this mode.
Entering the Manager Mode
To enter the manager mode, use the following procedure in the REG mode:
The manager code is stored in the manager file in advance.
If the code is not found in this file, an error occurs.
If the code is correct, the register enters the manager mode.
Override Entries
Programmed limits (such as maximum amounts) for functions can be overridden by placing the register in
the manager mode.
This example presumes that the register has been programmed not to allow coupon
entries over 2.00.
2
REG-mode entries 250
@
• • • • • •
Error
L
Enter to the
250
@
manager mode
Return to the REG
A
mode.
PrintKey operation
Example
Display
Example
µ e
The secret code entry box will appear.
XX
Manager code
XXXX
Secret code
When “0” is programmed for the secret code
Procedure
NOTE
7
{
69
ER-A280F_N(SEEG)(E)-4 09.6.12 11:11 AM Page 69