Instruction manual

140
Automatic tax 2 - 4 and VAT1 system
This system enables the calculation in the combination with automatic tax 2 through 4 and VAT1. This
combination can be any of tax 2 through 4 and VAT1. The tax amount is calculated automatically with the
percentages previously programmed for these taxes.
• A PLU not programmed for any of the tax statuses is registered depending on the tax status of
the department which the PLU belongs to.
• VAT/tax assignment can be printed at the fixed right position near the amount on the receipt as
follows:
VAT1/tax1 A
VAT2/tax2 B
VAT3/tax3 C
VAT4/tax4 D
When the multiple VAT/tax is assigned to a department or a PLU, a smaller number of the VAT/tax
will be printed. For details, contact your authorized SHARP dealer.
VAT shift entries
This feature is intended to shift the tax status of a particular department (or PLU) programmed for taxable 1 or
taxable 1 and taxable 3.
1. When the VAT shift entry is made for a particular department or PLU programmed for taxable 1, their tax
status shifts to taxable 2.
2. When this entry is made for a particular department (or PLU) programmed for taxable 1 and taxable 3, the tax
status “taxable 1” remains unchanged, but the other, “taxable 3” is ignored.
Press the
„
key to activate the VAT shift prior to entering department(s) or PLU(s) concerned.
„
550
8
:
◊
;
PrintKey operation
Example
Procedure
550
8
:
◊
;
PrintKey operation
Example
Note
(When the manual
VAT 1- 4 system
is selected)
(When the manual
VAT 1- 4 system
is selected)
FOR THE OPERATOR-A410/A420 02.4.20 6:51 PM Page 140