Instruction manual

77
Selection of X1/Z1 and X2/Z2 reports to be printed in the stacked report
sequence
Your register is equipped with the stacked report printing function that enables multiple X/Z reports to be printed
in sequence with only a single request.
• Maximum 70 steps are programmable. “1 step” means the memory size used for one no-range
type job no. The range type job no. needs “8 steps”.
• When Z of stacked report is initiated, X only reports will be skipped.
Job code numbers to be used are as follows.
*3: Both range setting and full setting are allowed.
2620
.≈
10
:
13
:
;
PrintKey operation
Example
Note
2620
.
≈
≈≈
:
;
Job no.
Start range
parameter
For full reporting (non-range report)
To cancel the stacked report sequence
To program for another Job no.
*
1
For individual reporting
End range
parameter
*
2
*
2
Procedure
2620
PGM 2
*1: Job no. Report name *2: Start/End range parameter Note
00 General
10 Full department
13 Full department group
20 PLU *3 Start PLU code/End PLU code (1 through 999999)
24 PLU stock *3 Start PLU code/End PLU code (1 through 999999)
27 PLU zero sales
29 PLU price category *3 Start price amount/End price amount
30 Transaction
31 Total in drawer
32 Commission sales
40 Full clerk
50 Full cashier
60 Hourly sales information *3 Start time/End time (0 through 2330) Range report is available
only in the X1 mode.
70 Daily net report
80 PBLU report *3 Start PLU code/End PLU code (1 through 9999)
82 Balance report
FOR THE MANAGER-2-A410/A420 02.4.20 6:49 PM Page 77