Service manual

9 OF 14
ECR LAB 4: ER-A450T
8. Can the SBTL key be programmed as compulsory before tendering?
 Yes  No
If yes, what PGM job code and/or bit is required?
 PGM 2616  SRV 916C  SRV 913D  Job 5 C, D, E  Job 9
9. Can voids and refunds be disabled in REG mode?  Yes  No
If yes, what PGM job code and/or bit is required?
 PGM 2616  SRV 931D  PGM 2320H
10. Can the COMPULSORY DRAWER CLOSE option be changed, so that the ECR
can be operated with the drawer open?  Yes  No
If yes, what PGM job code and/or bit is required?
 PGM 2616  SRV 916D  SRV 913D  Job 5 C, D, E  Job 9
11. How many times can you perform a validation?
 None  1  5  9  unlimited
12. What programming is needed to disable compulsory cashier sign on for
every transaction?
 PGM 2616  SRV 916C  SRV 913D  Job 5 C, D, E  SRV 910B
13. What programming is needed to print TOTALS –ONLY on the journal tape?
(Select all that apply):
 PGM 2616 2F  SRV 916C  SRV 913D  Job 5 C, D, E  Job 9
14. What does “H” on the operator display indicate?
 Help is required  Paper Release is not position properly  Paper has run out
15. What are the programming requirements to connect a scale?
(Select all that apply)
 PGM 2690  SRV 903  PGM 2691  SRV 906  SRV 945  SRV 946
 SRV 950  SRV 951  PGM 2210  PGM 2110  PGM 2231  PGM 2618
16. What does “PPPPPPPPPP” on the operator display indicate?
 Help is required  Paper Release is not position properly  Paper has run out
17. How many RS-232C ports are available with this model?
 None  1  2  3  4
Page 83 of 108