Operation Manual

145
Direct Key Programming
Use the following procedure to select direct-key programming:
Direct key
You can assign departments and PLUs directly to the keyboard. In the case of PLUs, you may assign up to
3 levels to be accessed directly on the keyboard. For key no. positions, refer to the illustration shown below.
In the case of selecting “061 DIRECT PLU”
• TYPE (Use the selective entry)
PLU: Assigns the key as a direct PLU key.
DEPT: Assigns the key as a direct department key.
• You can also select a direct PLU key by pressing the
corresponding key when the PLU has been assigned directly on
the keyboard instead of selecting the key from the menu.
• When selecting a department, the screen on which a
department code is to be entered (the message “DEPT.
CODE”) will appear.
• LEVEL1 through 3 (Use the numeric entry)
Enter a PLU code for each level. For example, if you want to
use this key as PLU code 1 (level 1) and PLU code 101
(level 2), enter 1 for “LEVEL1” and 101 for “LEVEL2.”
Key numbers
NOTE
Procedure
Select a pertinent key no. from the
key numbers list.
12 24 36 48 60 72 84 96 108 120 132 144 156
11 23 35 47 59 71 83 95 107 119 131 143 155
10 22 34 46 58 70 82 94 106 118 130 142 154
9 21 33 45 57 69 81 93 105 117 129 141 153
8 20 32 44 56 68 80 92 104 116 128 140 152
7 19 31 43 55 67 79 91 103 115 127 139 151
6 18 30 42 54 66 78 90 102 114 126 138 150
5 17 29 41 53 65 77 89 101 113 125 137 149
4 16 28 40 52 64 76 88 100 112 124 136 148
3 15 27 39 51 63 75 87 99 111 123 135 147
2 14 26 38 50 62 74 86 98 110 122 134 146
1 13 25 37 49 61 73 85 97 109 121 133 145
Departments and PLUs programmable area
• You can assign departments and PLUs only the “Departments
and PLUs programmable area” shown above.
• You cannot assign a department or a PLU to the position to
which a function key has been assigned.
NOTE
~ER-A750(SEEG)-8 97.3.31 3:49 PM Page 145