Specifications

‘,,
The date and time appear in the display, in reports, are printed at the top of each page
you transmit, and are”used for timer-operations. Set the da
keys on the operation panel as shown below.
+ To correct a mistake,
e and time by pressing th-e
press the SPEED key to move the cursor back to the mistake,
and then enter the correct number.
+ The day of the week is set by entering a code number. Code numbers are as follows:
Step
Press these keys: Comments
FUNCTION
1
(
)
@ ENTRY MODE will appear in the display,
2~ @
I DATE& TIME SET will appear in the display.
(Example)
Enter the day of the month (2 digits: “01” to “31“),
I
:~a
5 ,
Enter the month (2 digits: “01” for January, “02”
(Example:January) for February, “12” for December,etc.).
I
6
~ @ a
(Example: 1996)
Enter the last two digits of the year,
7 ~ @
Enter the day of the week by entering the
(Example: Thursday)
appropriatecode number (see above table).
(Example)
i Enter the hour (2 digits: “00” to “23”).
,
(Example)
‘ Enter the minute (2 digits: “00” to “59”).
I
START
10 ~
o
@
~
The clock will now start.
~ Exit.
INITIAL SETTINGS
2-5