Specifications

.
TIMEROPERATIONS
The timer function allows you to set a transmission or polling operation to be
performed automatically at a time you specify. Up to two transmission operations (one
from the feeder and one from memory) and one polling operation can be set at any
one time, and the times they will be performed can be specified up to a week in
advance.
You can use this function, for example, to take advantage of off-peak telephone rates
without having to be there when the operation is petiormed.
For a timer transmission, you can either scan the document into memory when you
set the transmission, or leave the document in the feeder before the transmission
time. Scanning the document into memory is convenient because you don’t have to
worry about document mix-ups or forgetting to load the document. If a transmission
from the feeder is set, a highlighted “T” will appear at the right of the display.
Code numbers are used to specify days of the week. Refer to the table below when
making time settings which include a specified day:
I
1
Day
SUN
MON TUE WED THU
FRI
SAT ;
Code o
4
1 ~ 2 3
45
6
J
Note: Only regular transmissions and polling operations can be set using the procedure
described below. If you want to set a broadcast, confidential, or relay request operation
to be performed at a specified time, program the operation into a Program Key and
include a timer setting. This is described in “Entering and Using Programs” in this
chapter.
Setting a timer operation
I
Step ~ Press these keys:
Comments
1
1
FUNCTION
a
I
TIMER MODE will appear in the display.
1
.
I
2 ~
a
Select SET.
1
I
!
B ‘r m
Press “#” to set a transmission operation (SEND ~
3 ~8®••8®•
MODE), or “*” to set a polling operation
(POLLING MODE).
SPECIAL FUNCTIONS
6-13