User manual
Table Of Contents
- TABLE OF CONTENTS
- ABOUT THIS MANUAL
- BEFORE USING THE MACHINE AS A FAX
- ENTERING DESTINATIONS
- BASIC TRANSMISSION METHODS
- FAX RECEPTION
- SPECIAL MODES
- SPECIAL MODES
- STORING FAX OPERATIONS (Program)
- ERASING PERIPHERAL SHADOWS ON THE IMAGE (Erase)
- TRANSMITTING AN ORIGINAL AS TWO SEPARATE PAGES (Dual Page Scan)
- SENDING A FAX AT A SPECIFIED TIME (Timer)
- SENDING TWO PAGES AS A SINGLE PAGE (2in1)
- SENDING BOTH SIDES OF A CARD AS A SINGLE PAGE (Card Shot)
- SENDING A LARGE NUMBER OF PAGES (Job Build)
- TRANSMITTING ORIGINALS OF DIFFERENT SIZES (Mixed Size Original)
- FAXING THIN ORIGINALS (Slow Scan Mode)
- ADDING YOUR SENDER INFORMATION TO FAXES (Own number sending)
- CALLING A FAX MACHINE AND INITIATING RECEPTION (Polling)
- SENDING A FAX WHEN ANOTHER MACHINE POLLS YOUR MACHINE (Polling Memory)
- PERFORMING F-CODE COMMUNICATION
- USING AN EXTENSION PHONE
- CHECKING THE STATUS OF FAX JOBS
- PRINTING A TRANSACTION REPORT / IMAGE SENDING ACTIVITY REPORT
- IF THE MACHINE IS MOVED
28
WHEN THE LINE IS BUSY
If the line is busy when you send a fax, transmission will be re-attempted automatically after a preset interval. This
function only operates in memory transmission mode. In direct transmission mode or manual transmission mode, the
transmission will be cancelled. Wait briefly and then try sending the fax again.
WHEN A COMMUNICATION ERROR OCCURS
If a communication error occurs or the other fax machine does not answer the call within a preset period of time,
transmission will be re-attempted automatically after a preset interval. This function only operates in memory
transmission mode.
To cancel transmission...
Cancel the transmission from the job status screen.
☞ CANCELLING A FAX IN PROGRESS OR A RESERVED FAX (page 121)
System Settings (Administrator): Recall in Case of Line Busy
This is used to set the number of recall attempts and the interval between attempts when the connection cannot be
established because the line is busy. The factory default setting is 2 attempts at an interval of 3 minutes.
To cancel transmission...
Cancel the transmission from the job status screen.
☞ CANCELLING A FAX IN PROGRESS OR A RESERVED FAX (page 121)
System Settings (Administrator): Recall in Case of Communication Error
This is used to set the number of recall attempts and the interval between attempts when a transmission fails due to an error.
The factory default setting is attempt at an interval of 1 minute.