Service manual

1 – 1
UX-510UA
FO-1470U
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications
Automatic dialing: Rapid Key Dialing: 36 numbers
Speed Dialing: 63 numbers
Imaging film: Initial starter roll (included with
machine): Approx. 60 letter-size pages
Replacement roll:
UX-15CR/FO-15CR (One roll yields
approx. 500 letter-size pages)
Memory size* : 512 KB (approx. 30 average pages with
ECM turned off)
Modem speed: 14,400 bps with Automatic Fallback to
2400 bps.
Transmission time* : Approx. 6 seconds
Resolution: Horizontal:
203 pels/inch (8 dots/mm)
Vertical:
Standard: 98 lines/inch
(3.85 lines/mm)
Fine/Halftone: 196 lines/inch
(7.7 lines/mm)
Super fine: 391 lines/inch
(15.4 lines/mm)
Automatic document feeder: 20 sheets max.
Recording system: Thermal transfer recording
Halftone (grayscale): 64 levels
Display: 7 x 5 dots, 1 line by 16-digit display
Paper tray capacity: Letter: 200 sheets
(16-to 20-lb. paper) Legal: 200 sheets
Compression scheme: MH, MR, MMR
Applicable telephone line: Public switched telephone network
Compatibility: ITU-T (CCITT) G3 mode
Input document size: Automatic feeding:
Width  5.83 to 8.5"
(148 to 216 mm)
Length  5.04 to 11"
(128 to 279 mm)
Manual feeding:
Width  5.83 to 8.5"
(148 to 216 mm)
Length  5.04 to 39.4"
(128 to 1000 mm)
Effective scanning width: 8.2" (208 mm) max.
Effective printing width: 8.1" (206 mm) max.
Contrast control: Automatic/Dark selectable
Reception modes: TEL/FAX/A.M. (Note: A.M. mode is for
connecting an answering machine)
Copy function: Single/Multi/Sort (99 copies/page)
Telephone function: Ye s
(cannot be used if power fails)
Power requirements: 120 V AC, 60 Hz
Operating temperature: 41 to 95°F (5 to 35°C)
Humidity: Maximum: 80 % RH
Power consumption: Stand-by: 3.6 W
Maximum: 100 W
Dimensions: Width: 14.4" (365 mm)
Depth: 19.0" (482 mm)
(With attachments)
Height: 10.6" (270 mm)
(With attachments)
Weight: Approx. 10.6 lbs. (4.8 kg)
* Based on ITU-T (CCITT) Test Chart #1 at standard resolution in Sharp
special mode, excluding time for protocol signals (i.e., ITU-T phase C
time only).
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product
improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some
deviation from these values in individual units.