Service manual

FO-4400U

FO-CS1

Loading paper in the paper cassette (if installed FO-CS1)

Note: To use A4 paper in the paper cassette, you must have a service

technician adjust the cassette.

Grasp the hand-hold on the cassette and pull the cassette out until it

stops.

Push the pressure plate down until it locks into position.

Squeeze the paper guide and pull up to move it to the appropriate

holes for the length of the paper. Push the guide down into the holes.

Place a stack of paper in the cassette, print side up.

• Make sure the stack of paper is not higher than the two tabs on the

paper guide and the two metal tabs. If it is, remove some of the

paper.

• If you find it difficult to load the paper, remove the cassette from the

machine. (Pull the cassette out as far as it will go, grasp the left

side of the cassette with your left hand, and then lift it up and out

with both hands.)

Push the cassette back into the machine, making sure it clicks into

place.

5. Clearing paper jams

Clearing a jammed document

If the original document doesn’t feed properly during transmission or

copying, or REMOVE ORIGINAL(S) appears in the display, fist try press-

ing

START/

ENTER

. If the document doesn’t feed out, open the operation panel

and remove it.

Important: Do not try to remove a document without opening the opera-

tion panel. This may damage the feeder mechanism.

Open the operation panel.

• Squeeze the release marked PANEL RELEASE and pull up.

Remove the document.

Close the operation panel, making sure it clicks into place.

1 – 7