Service manual
FO-IS125N
1 – 10
9. Resetting the drum counter
Each time you install a new drum cartridge, follow the steps below to
reset the drum counter to zero.
1) Press and then until [LIFE] appears in the display.
2) Press , then until [CLEAR DRUM COUNTER]
appears.
3) Press .
10. Manually resetting the toner counter
When a new toner cartridge is installed, the toner counter is reset in
Step 9 on the previous page. The procedure below is normally not nec-
essary; however, it can be used in the event that you need to reset the
toner counter manually.
1) Press and then until [LIFE] appears in the display.
2) Press , then until [CLEAR TONER COUNTER]
appears.
3) Press .
11. Loading printing paper
You can load letter or legal size paper in the paper tray.
Maximum number of sheets
(20-lb. copy bond paper at room temperature)
Letter: Approx. 250 sheets
Legal size: 100 sheets
Caution! Do not use the blank side of paper that has already been
printed on.
1) Fan the paper, and then tap the edges against a flat surface to
even the stack.
2) Pull the paper plate forward . Squeeze the paper guide and
adjust it to the width of the paper . Insert the stack of paper into
the tray, print side up .
• Maximum stack height should not be higher than the line on the
paper guide.
3) Push the paper plate back.
• If you loaded legal size paper (or you changed the paper size),
change the paper size setting as explained.
INFO
START
INFO
START
1
2
3
2
1
3