Service manual

FO-IS125N
1 – 8
4. Connecting the power cord
Plug the power cord into a 120 V, 60 Hz, grounded AC (3-prong) out-
let.
Do not plug the power cord into any other kind of outlet. This will
damage the machine and is not covered under the warranty.
5. Connecting the telephone line cord
Insert one end of the line cord into the socket on the back of the
machine marked TEL. LINE. Insert the other end into a wall telephone
socket.
6. Affixing the rapid key labels
Affix each strip of Rapid Key labels above each row of letter keys as
shown in the panel illustration.
7. Connecting the machine to your network
To use the Scan to E-mail and Scan to Folder functions, and to use the
machine as a printer, you must connect the machine to an Ethernet
network. In addition, to use Scan to E-mail, the network must have an
Internet connection. A typical setup is shown below.
The machine is connected using an Ethernet cable (not included).
Please purchase a 10Base-T/100Base-TX straight-through (regular)
cable.
Connect one end of the cable to the LAN port on the machine. Con-
nect the other end to a LAN port on your switch or hub.
If you are uncertain which port to connect the cable to, see the
manual for the router, switch or hub.
The connections can be made with all devices powered on.
8. Installing the toner cartridge and drum cartridge
The laser printer in the machine uses a toner cartridge and a drum car-
tridge.
The starter toner cartridge included with the machine can print
approximately 1500 letter-size pages at 5% page coverage.
When replacing the toner cartridge, use a SHARP FO-25ND toner
cartridge. One cartridge can print about 3000 letter-size pages at
5% coverage.
The drum cartridge can print approximately 20,000 letter-size
pages. When replacing the drum cartridge, use a SHARP FO-
25DR drum cartridge.
Follow the steps below to install the toner cartridge and the drum car-
tridge.
Note: The quality of the toner cartridge is guaranteed for 18 months
after the date of manufacture indicated on the package. The quality of
the drum cartridge is guaranteed for 24 months after the date of manu-
facture indicated on the package.
1) Open the top cover of the machine.
Caution! The fusing unit inside the print compartment becomes
very hot during operation. Do not touch the inside of the print com-
partment after the machine has been in operation.
The machine is initially set for tone dialing. If you are on a pulse dial
line, change the “DIAL MODE” setting.
To communicate on your network, the machine must have an IP
address. To set the machine’s IP address and configure other net-
work settings.