User Manual

Optional Settings
174
Setting 21: ALARM VOLUME
This sets the volume of the beep sound that alerts you to error conditions and
informs you that operations have been completed. Press or to
select a volume level (HIGH, LOW or OFF) and then press .
♦ Initial setting: LOW
Note: Setting 22 is not used.
Setting 23: QUICK ON-LINE
When you transmit a multi-page document, this setting determines whether
the machine will dial the receiving party and begin transmitting while scanning
is still in progress, or wait until all pages have been scanned before dialling.
Select ON to have the machine dial and begin transmission while scanning is
still in progress, or OFF to have the machine wait until all pages have been
scanned. Press or to make the selection and then press .
♦ Initial setting: ON
Setting 24: MULTI TTI
If you are using Department Control, you can select ON to have the
department name (the name associated with the department code entered by
an operator to access the fax) appear at the top of each transmitted
document. This will appear in place of the name entered in
Entering Your
Name and Fax Number
in Chapter 1. Select OFF to turn Multi TTI off (the
sender’s name entered in Chapter 1 will appear). Press or to
make the selection and then press .
♦ Initial setting: OFF
Setting 25: BEEP LENGTH
This sets the duration of the beep that signals the end of transmission,
reception, and copying. Press or to select a duration (3
SECONDS, 1 SECOND, or NO BEEP) and then press .
♦ Initial setting: 3 SECONDS
Note: Setting 26 is not used.
START/
ENTER
START/
ENTER
START/
ENTER
START/
ENTER
all.bookPage174Wednesday,May21,20036:03PM