User Manual
Optional Settings
176
Setting 31: SEPARATE MODE
If desired, you can have the fax draw a sheet of paper from one of the paper
sources after each fax reception. By loading coloured (or large) paper in that
source, each coloured sheet drawn will act as a separator that makes it easy
to distinguish where one multi-page document ends and another begins. A
Transaction Report printed after a reception will also be printed from that
paper source to act as a separator sheet. To turn on this function, press
or to select YES, select the paper source for the separator paper, and
then press . After turning on the function, be sure to load appropriate
paper in the selected paper source. To turn off Seperate mode, press or
to select NO and then press . (Note that the function will turn off
automatically if the selected paper source runs out of paper.)
Note: This setting is only available if your dealer has installed the paper cassette
option.
♦ Initial setting: NO
Note: If you turn off the Separate Mode setting, Option Setting 16 will
subsequently appear in the display to allow you make an appropriate setting for
cassette selection. If you don’t make a selection, AUTO SELECTION will be
automatically selected.
Setting 32: BACKLIGHT SETTING
Use this setting to set the amount of time until the display backlight turns off
after the operation panel is used (after a key is pressed). Press or
to select the amount of time (3 MINUTES, 10 MINUTES, or 15 MINUTES), or
select ALWAYS OFF if you never want the backlight to be on. When finished,
press .
♦ Initial setting: 3 MINUTES
Note: Setting 33 and 34 are not used.
START/
ENTER
START/
ENTER
START/
ENTER
all.bookPage176Wednesday,May21,20036:03PM