Specifications

ENGLISH
2
Remove the Humidifying Filter from the
Humidifying Tray. Drain accumulated wa-
ter by tilting the Humidifying Tray slowly.
1
Remove the Water Tank and Humidifying
Tray.
E-11
Frequency of maintenance cycle will depend on the hardness
of the water. Avoid spilling water when removing or cleaning
the tray.
3
Rinse the inside of the Humidifying
Tray with lukewarm water to remove
impurities.
• Do not remove the Styrofoam oat.
• Clean difcult-to-reach parts with a cotton-
tipped swab or tooth brush.
CAUTION
If the Styrofoam oat comes off,
replace by inserting the tabs of
the Float into the holes in the
Humidifying Tray as shown in the
diagram.
When Water Deposits are Difcult to Remove
• Use only mild kitchen detergents to
clean the Humidifying Tray. Use of
non-designated chemicals or deter-
gents can cause deformation, tar-
nishing, cracking (water leakage).
Insert the oat below
this tab.
Insert the tab on
the other side of the
oat into the hole.
Insert the tab of the
oat into the hole.
1
Fill Humidifying Tray half-
way with lukewarm water,
add a small amount of mild
kitchen detergent, and leave
to soak for about 30 min-
utes.
Dilute detergent according to
instructions on the container.
Clean difcult-to-reach parts
with a cotton swab or tooth
brush.
2
Rinse the Humidifying
Tray with lukewarm wa-
ter.
• Rinse until all detergent residue
is removed.
• Inadequate rinsing may cause
the detergent odour or changes
in the shape/colour of the main
unit.
HUMIDIFYING TRAY
Care Cycle
1 month
Unlatch the Water
Tank first, then re-
move the tray. Use
both hands when
pulling out the Hu-
midifying Tray to
avoid spilling water.
Humidifying Filter
Humidifying Tray
KC-930TA.indd 31 09.9.30 2:23:00 PM