Operation Manual

Call Manager 80
Setting the Charge Rate
Set the charge rate to calculate the call cost and set the
maximum limit for call cost.
1. Perform steps 1 to 4 in “Checking the Cost of the
Last Call” on page 79.
2. Press or to select “Cost Units”, then press
.
3. Press or to select “Set Units”, then press
.
4. Enter your PIN2 code, then press .
5. Enter a cost per unit, then press .
To enter a decimal point, press .
6. Enter a currency unit (up to 3 characters), then press
.
Checking the Charge Rate
1. Select “Read Units”, then press at step 3 in
“Setting the Charge Rate”.
The charge rate is now displayed.
2. When you have finished, press [Back].
Setting the Charge Limit
This function is useful if you wish to make sure you do
not exceed a certain charge limit.
1. Perform steps 1 to 4 in “Checking the Cost of the
Last Call” on page 79.
2. Press or to select “Max Cost”, then press
.
3. Press or to select “Set Limit”, then press
.
4. Enter your PIN2 code, then press .
5. Enter a value, then press .
To enter a decimal point, press .
Checking the Charge Limit
1. Select “Read Limit”, then press at step 3 in
“Setting the Charge Limit”.
The value of the charge limit is now displayed.
2. When you have finished, press [Back].