Operation Manual

148 Contacts
Checking the Total Call Cost
1. Perform steps 1 to 4 in “Checking the Cost of the
Last Call” on page 147.
2. Press a or b to highlight “All Calls”, then press
to select.
3. When you have finished, press C [Back].
Setting the Charge Rate
Set the charge rate to calculate the call cost and set the
maximum limit for call cost.
1. Perform steps 1 to 4 in “Checking the Cost of the
Last Call” on page 147.
2. Press a or b to highlight “Cost Units”, then press
to select.
3. Press a or b to highlight “Set Units”, then press
to select.
4. Enter your PIN2 code, then press .
5. Enter a cost per unit, then press .
To enter a decimal point, press R.
6. Enter a currency unit (up to 3 characters), then press
.
Checking the Charge Rate
1. Perform steps 1 to 4 in “Checking the Cost of the
Last Call” on page 147.
2. Press a or b to highlight “Cost Units”, then press
to select.
3. Press a or b to highlight “Read Units”, then press
to select.
The charge rate is now displayed.
4. When you have finished, press C [Back].
Setting the Charge Limit
This function is useful if you wish to make sure you do
not exceed a certain charge limit.
1. Perform steps 1 to 4 in “Checking the Cost of the
Last Call” on page 147.
2. Press a or b to highlight “Max Cost”, then press
to select.
3. Press a or b to highlight “Set Limit”, then press
to select.
4. Enter your PIN2 code, then press .
5. Enter a value, then press .
To enter a decimal point, press R.