Service manual

GX30
2 – 18
CONFIDENTIAL
4.4.3 Error message list
Below is the list of error messages for the upgrading tool (on the PC side) and Loading loader (on the handset side).
1) Error messages for the upgrading tool (on the PC side)
2) Error messages for Loading loader (on the handset side)
* When No.1 occurs, handset screen shows error messages for No.2 to No.8 as well as the address (No.10) and status (No.11) of the error source
at the same time.
No. Message Descriptions/Instructions
1 Select a file for Downloading or check the box of Initializing. Load File is not set.
Select a MOT file.
2 Unable to open file. Failed to open the MOT file.
Start over the rewrite operation.
3 You need to set the Wait Time! WaitTime (S) is not set.
Set WaitTime (S) value.
4 The file you selected is unsuitable for Upgrading. The selected file cannot be rewritten for upgrading.
Select an appropriate MOT file.
5 Cannot Setup COM port. The selected COM port does not exist or is used for other opera-
tions.
Select a COM port connected to the PC cable.
6 RAM Loader not responding to Commands. No response from Loading loader.
Start over the rewrite operation.
7 RAM Loader responding Parameter Error. Information sent from the PC is illegal.
Reinstall the upgrading tool.
Start over the rewrite operation.
8 RAM Loader responding Flash Error (XXXX). Failed to initialize FLASH ROM in (XXXX).
Start over the rewrite operation.
9 Correspondence Error. Undefined response from Loading loader.
Start over the rewrite operation.
No. Message Descriptions/Instructions
1 FLASH_ERROR An error in Flash Rom.
Start over the rewrite operation.
2 ERROR_PARAM The upgrading tool is damaged.
Uninstall and reinstall the upgrading tool, and start over the rewrite
operation.
3 ERROR_WPROTECT Flash Rom is protected.
Battery may be too low.
Use a sufficiently charged battery and start over the rewrite opera-
tion.
4 ERROR_READ Failed to read Flash Rom data and the operation was aborted.
Start over the rewrite operation.
5 ERROR_WRITE Failed to write to Flash Rom and the operation was aborted.
Start over the rewrite operation.
6 ERROR_ERASE Failed to erase Flash Rom data and the operation was aborted.
Start over the rewrite operation.
7 ERROR_VERIFY The rewrite operation was aborted since there was a mismatch
between data written to Flash Rom and that written to handset.
Start over the rewrite operation.
8 ERROR_RWE_TMOUT Communication was terminated since there was no response from
Flash Rom for a certain period of time.
Start over the rewrite operation.
9 CORRESPONDENCE_ERROR Communication was terminated since serial data communication
failed.
Start over the rewrite operation.
10 ADR = XXXXXXXX Indicates the address of Flash (the error source).
11 STR =XX Indicates the status of Flash (the error source).