Service manual

GX30
2 – 54
CONFIDENTIAL
4. Battery does not charge.
5. Vibrator does not work.
Set a battery of 3.8 - 3.9 V and connect the charger. CN701 and CN103 are connected improperly, and IC103 is
defective.
Is the mobile light turned on red? Does the waveform periodically change between “H” and “L”
at R701?
Set a battery of 4.0 - 4.2 V. Click the “Performance check
adjustment” button on SPST.
LED702 of the mobile light is defective.
* For settings and connections for SPST, refer to the “ADJUSTMENTS,
PERFORMANCE CHECK, AND FIRMWARE UPGRADE” (see page 2-1).
Click the “Temperature adjustment” button. Is the value of
“temp” normal? (Measurement tolerance: ± 5 deg.)
TH701, TH101, and IC103 are defective. CN701 and CN103
are connected improperly.
Click the “Battery voltage check” button. Is the voltage 4.0 -
4.2 V?
IC103 is defective.
Set a battery of 3.3 - 4.2 V and start in normal mode.
Connect the charger to the external connector. Is the voltage
applied to TP537 higher than that of battery?
R535, R536, Q108, IC115, and IC103 are defective.
When the charger is inserted to the external connector, is
IC115 pin 1 at “L”?
IC115 is defective.
Connect the charger to the external connector. After approx.
15 seconds, do the voltages on TP180 and TP520 increase by
more than 0.05 V?
R535, R536, Q108, IC115, IC103, D103, and D105 are defec-
tive.
The battery is defective, or the battery cycle is shortened.
Are vibrator terminals in contact with the land?
Are terminals and the land clean?
Vibrator is deformed and defective. (When vibrator terminals
and the land are dirty, clean or replace them.)
Hereafter check with Vibrator working.
Is rectangular wave of 3 V sent to between Vibrator terminals
in sync with the vibration pattern?
Vibrator is defective.
Is VBAT voltage applied to IC109 pin 5? IC109 is soldered improperly.
Is signal synchronized with the vibration pattern sent to IC109
pin 1?
IC109 is defective.
Is signal synchronized with the vibration pattern sent from
IC105 pin 19?
IC105 is soldered improperly.
R158, C167 and C168 are defective.
Is approx. 3 V applied to IC105 pin 7? R158, C167 and C168 good in appearance and mounted
properly?
IC105 is defective, or the control signal line to IC106 is defective.
YES
NO
NO
YES YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
YES
NO
NO
YES
YES
NO
YES
NO
NO
NO
YES YES