Installation manual

Installation 1-38 CX34/44/54-series
Interconnecting cable (DX45 + DX60)
1. Run the cable and fasten it at intervals of about 40 cm.
2. Remove the upper part of the radome from the scanner (loosen 4 screws
with incl. Allen key). Avoid bumping it against the antenna by lifting it
vertically.
3. Remove the shield cover located on the astern side (8 screws) - use a T20
screwdriver.
4. Pass the cable up through the opening and place the cable screen into the
groove (Fig.1), and then position the rubber ring at the cable inlet and
tighten the coupling ring.
5. Attach the thick wires to the included 8-pin connector and the thin wires to
the included 11-pin connector (Fig.2). Fix connectors to PCB (Fig.1).
6. Replace the shield cover. Be careful that no cables are caught between main
unit and cover, and that the antenna is free to rotate.
7. Replace the upper part of the radome (Fig.3): Be careful not to bump it
against the antenna. The small alignment mark on the upper part should be
positioned just above the cable inlet where there is a similar mark on the
lower part. The holes for the 4 screws should now be aligned. Tighten the
screws to 1.5 Nm (max).
8. Ensure the display unit’s radar function is off. Connect the cable to the
receptacle marked RADAR on the rear panel of the display unit.