User's Manual

191
Settings
Security
Enabling/Disabling the PIN Code
If the PIN code is enabled you are asked to enter the PIN code each time the phone is
switched on. Your PIN code is registered on the SIM/USIM card and you should have been
made aware of the code when you purchased the SIM/USIM card. Contact your service
provider for further details.
“Settings”
→ “Security Settings” → “PIN Entry” → “Switch On/Off”
1. Select “On” to enable the PIN code or “Off” to disable.
2. Enter your PIN code.
Note
• If you enter the wrong PIN code three times in step 2, the SIM/USIM card will lock. To
remove the lock, contact your service provider/SIM/USIM card vendor.
To Change the PIN Code
This allows you to change the PIN code registered on the SIM/USIM card. Before you change
the PIN code, select “On” in step 1 in “Enabling/Disabling the PIN Code”.
“Settings”
→ “Security Settings” → “PIN Entry” → “Change PIN”
1. Enter the existing PIN code.
2. Enter a new PIN code.
3. Enter the new PIN code again.
(M 12-8)
e_j350.book Page 191 Monday, October 25, 2004 6:33 PM