User's Manual

e02_dt20_7e.fm
[51/56]
51
Continued on next page
Before Using the Handset
2
When insert the AC adapter power plug into an
outlet or insert the DC adapter power plug into a car
cigarette lighter socket, charge start sound is heard,
charging LED illuminates, and charging starts.
3
When Charge end sound is heard and charging
LED turns off, charging is complete.
When removing the connector, always hold the release buttons
on both sides (
1 ) and unplug it by pulling out horizontally ( 2 ).
[Read “Desktop holder SH17 (sold separately) user’s
guide” carefully.]
Battery pack can be charged with the FOMA terminal open or in the
Cycloid position.
1
Face the side with the arrows of the AC adapter
connector down and insert it into the connector
terminal of the desktop holder.
Keeping the connector parallel with the desktop holder, firmly
push it all the way in until it clicks.
2
Insert the AC adapter power plug into an outlet.
3
Place the FOMA terminal into the desktop holder.
Charge start sound is heard, Charging LED
illuminates, and charging starts.
Note
Do not forcibly insert or remove. May cause damage to the
external connector terminal and the connector.
100 VAC
outlet
For AC adapter
2
For DC adapter
Cigarette
lighter socket
2
1
2
1
Connector
(Face the side with the arrows up)
Pull the adapter out of the outlet or cigarette lighter socket if it will
not be used for a long time.
Do not forcefully pull the cover on the external connector terminal.
May damage the cover.
Do not place objects near the FOMA terminal when charging. The
FOMA terminal may be damaged.
When using a DC adapter
The DC adapter should only be used in negative grounded
vehicles (12 and 24 VDC).
Do not use with the car engine shut off. May drain the car battery.
The DC adapter fuse (2A) is a consumable. For replacement,
purchase a new fuse at a local automobile supply shop.
Refer to the FOMA DC Adapter 01/02 (sold separately) user’s
guide for details.
Charging using the desktop holder
Note
dt20_E.book 51 ページ ２００７年１２月１２日 水曜日 午後２時３分