User's Manual

e02_dt20_7e.fm
[53/56]
53
Continued on next page
Before Using the Handset
[Battery empty. Unsaved data will be lost. Ending
current operation] appears if battery starts to run out
(Press t to clear the message).
After a while, an alert tone sounds. The warning screen
stating that the battery runs out appears, handset operations are
disabled and power turns off after approximately 60 seconds.
During a voice/Videophone call, the alert tone sounds and [Battery
empty. Unsaved data will be lost. Ending current operation]
appears. The call is disconnected after approximately 20 seconds.
At the same time, the screen above appears and after
approximately 60 seconds, the power turns off.
Alert tone does not sound when Manner mode or Public mode
(Drive mode) is set (Alert tone sounds during a call).
1
Press H (for 2+ seconds).
It may take some time for the wakeup
screen to appear.
The wakeup screen appears followed by the
initial settings screen. Proceed to initial
settings (nP. 54 ) .
If initial settings have been completed, the
screen shown on the right appears when
power is turned on. This screen is called the
“stand-by display”.
■ Turning the power off
1
Press H (for 2+ seconds).
It may take some time for the power to be
turned off (The end screen appears on the
display until the power is turned off).
1
In the Custom menu, select [設定]/[一般設定]/
[Bilingual]/ [English].
If the battery runs out
Power ON/OFF
Turning the power on and off
Turning the power on
Initial settings
screen
Note
If initial settings are not yet completed, the setting screen appears
every time the power is turned on.
If the FOMA card is not inserted, [Insert UIM] and a FOMA card
error appear (nP. 37).
When [Enter PIN1 code] appears, enter the PIN1 code ( n P. 132).
When a FOMA card is replaced with a new card, the terminal
security code (four to eight digits) must be entered after turning on
the terminal. If a correct terminal security code is entered,
stand-by display appears. When a wrong terminal security code is
entered five times, the power is turned off. However, turning on the
power again is possible.
When A (Out of service area) appears, the handset is outside the
service area or in a place with no signal. Move to a place where the
icon disappears.
Select language
Switching the display to English
Stand-by display
dt20_E.book 53 ページ ２００７年１２月１２日 水曜日 午後２時３分