User's Manual
56
e02_dt20_7e.fm
[56/56]
Before Using the Handset
Specifications made when making a call take priority over the
method for setting in advance.
1
In stand-by, enter a phone number/C/[Caller ID
setting].
2
Select the setting.
To notify caller ID: Select [Send own no.].
To not notify caller ID: Select [No caller ID].
To follow the Notify caller ID of the network service (nP. 55 ) :
Select [As NW setting].
3
Press s (Phone)/i (V.phone)/& (q) (PushTalk).
1
In the Custom menu, press 0.
Setting up Notify caller ID/No caller ID when
making a call
Note
Alternatively, set caller ID from Submenus in the Phonebook,
Redial or Received calls details screen.
The method for specifying the caller ID setting when making a
voice call is available for PushTalk transmissions. However, the
setting cannot be be made by entering a phone number after 186
or 184 is selected.
Related Operations
Add 186 when dialing (Notify caller ID)
In stand-by, press 186/enter a phone number/
s (Phone)/i (V.phone).
Add 184 when dialing (No caller ID)
In stand-by, press 184/enter a phone number/
s (Phone)/i (V.phone).
Own number
Checking your phone number
Note
When a change for the Number B of 2in1 or a FOMA card
exchange (2in1 subscriber b 2in1 subscriber) is performed, use
the following methods to obtain the correct Number B.
Set 2in1 function OFF and then perform 2in1 setting again
Check the 2in1 subscription
When a FOMA card exchange (2in1 subscriber b 2in1
nonsubscriber) is performed, set 2in1 function OFF.
Related Operations
Show a telephone number during voice call
During a voice call, press C/[Own number].
Show a telephone number during a Videophone call
During a Videophone call, press C/[Own number].
In the Dual mode (while using 2in1), switch between
own numbers of Number A and Number B
In the Own number screen, press i.
dt20_E.book 56 ページ 2007年12月12日 水曜日 午後2時3分