User Manual

337
e15_dt25_7e.fm
[337/346]
Data Display/Edit/Management
Use the FOMA terminal’s Infrared port from i-appli software
to operate equipment supporting the infrared remote control
such as TVs and VCRs.
To use the infrared remote control function, download compatible
i-appli software.
Start i- a ppli software that supports Ir remote control functions, point the
FOMA terminal’s Ir port to the front of the remote control sensor on the TV,
VCR or other device to operate, and perform remote control operations.
Actual operational methods will differ with each i-appli software
application.
Control devices from a distance of up to approximately 4 m
(Distance will vary depending on the device, the ambient brightness
and other factors).
Use iC transmission to send and receive data to and from
other FOMA terminals which also support iC transmission
function.
During iC transmission, the FOMA terminal status is the same as
when outside the service area, such that making/receiving calls,
i-mode, and data communications are not possible.
iC transmission is not available while a call is in progress or the IC
card is locked.
Data that can be sent and received or operations when various lock
functions are set are same as for Ir exchange (nP. 333).
For details on starting iC transmission from i-appli nP. 251
Note
When i- a ppli To is set to [No], i- a ppli is not activated from Ir exchange.
Cannot be activated as i-appli stand-by.
Infrared remote control
Using the infrared remote control function
Remote control operation
15°
Approx. 4 m
15°
Infrared port
Note
When in the Self mode, the Ir remote control function cannot be
used.
Depending on the device, operation may not run properly.
Remote control operation may not run properly directly under
fluorescent lights, near other equipment using infrared signals, or
in areas of direct sunlight.
iC transmission
iC transmission
dt25_E.book 337 ページ ２００８年５月１４日 水曜日 午後３時１１分