Operation Manual

47
Continued on next page
Before Using the Handset
1
In the Custom menu, select [Settings]/[General
settings]/[Check status]/[Battery level].
: Wait approximately 2 seconds and the display disappears.
: The battery level sound is heard at the volume set in Key/
Standby i-motion (nP. 98).
[Battery empty. Unsaved data will be lost. Ending
current operation] appears if battery starts to run out
(Press t to clear the message). After a while, an
alert tone sounds. The warning screen stating that the
battery runs out appears, handset operations are disabled and power
turns off after approximately 60 seconds.
During a voice/Videophone call, the alert tone sounds and [Battery
empty. Unsaved data will be lost. Ending current operation]
appears. The call is disconnected after approximately 20 seconds.
At the same time, the screen above appears and after
approximately 60 seconds, the power turns off.
Alert tone does not sound when Manner mode or Public mode
(Drive mode) is set (Alert tone sounds during a call).
1
Press H (for 2+ seconds).
: It may take some time for the wakeup
screen to appear.
: The wakeup screen appears followed by the
initial settings screen. Proceed to Initial
setting (nP. 48).
When the FOMA terminal placed in the desktop holder is set to the
Cycloid position, operate while holding it so as not to come off
from the desktop holder.
Battery level
Checking battery level
Checking battery level with sound and display
Graphic
Sound Three beeps Two beeps One beep
Status
Battery is
sufficiently full.
Battery is
running low.
Battery is almost
empty. Charge
the battery.
"
Battery level is still sufficient.
#
Battery level is low.
$
Battery is almost empty. Charge the
battery.
%
Battery is empty (Power will turn off
soon).
{
Battery pack is being charged.
If battery runs out
Power ON/OFF
Turning power ON/OFF
Turning power ON
Initial settings
screen