User's Manual

91
j07_2_pr35.fm
[91/100] ~~~~~ ~~~~~ ~~~~~ ~~~~~ ~~~
そ
の
他
1 Push the back cover in the direction of the arrow
(1), slide approximately 3 mm (2) and remove
the back cover (3)
2 Pull out the tray straight (1). Set the UIM on the
tray with the IC (gold) side turned up (2) and push
the tray all the way in (3)
3 Turn a recycle mark side up, match tabs and
attach the battery pack
4 Place the back cover to the FOMA terminal slot
with the back cover open approximately 3 mm,
push it (1) and slide it to the direction of arrow
to insert (2)
1 Insert the AC adapter into the connector terminal of the desktop holder
2 Insert the AC adapter power plug into an outlet
3 Place the FOMA terminal in the desktop holder in the direction of the
arrow until it clicks (1)
Charge start sound is heard, charging LED illuminates, and charging starts.
4 Hold the desktop holder and lift the FOMA terminal out when charging is
complete
Charge end sound is heard and charging LED turns off when charging is
complete.
Before Use
Inserting UIM (FOMA card) and battery pack
Perform with the FOMA terminal turned off and closed while holding with your
both hands. Note that excessive force may damage the FOMA terminal, UIM
and battery pack.
Notch
IC (gold)
123
Tray
Notch
Tabs
Back cover
Securely close the back cover. If not closed securely, the back cover may
come off and the battery pack may fall out due to vibration.
Charging
Pull the AC adapter out of the outlet when left unused for a long period of
time.
When charge start sound is not heard or when charging LED does not
illuminate, check that the FOMA terminal is placed securely in the desktop
holder (except when terminal is turned off, manner mode is set or charge start
sound is silent).
When placing the FOMA terminal in the desktop holder, be careful not to
catch a strap, etc.
Connector (Turn the
side with the arrows up)
FOMA AC
Adapter 01/02
Charging LED
1
pr35_uj.book 91 ページ ２０１０年５月１７日 月曜日 午後４時１６分