User Manual

32
Before Using the Handset
2
Attach the battery pack
: With the recycle mark side turned up, place
the connector terminal of the handset to that
of the battery pack and attach the battery
pack.
3
Attach the back cover (nP. 23)
1
Remove the back cover (nP. 23)
2
Remove the battery pack
: The battery pack has a tab that makes it
easy to remove. Hook a finger on the tab to
prevent excessive force on it and remove the
battery pack upward.
3
Attach the back cover (nP. 23)
The battery pack is not fully charged at the time
of purchase. Be sure to charge the battery
before use.
It is recommended that the accompanying
desktop holder be used for charging to prevent
water from seeping or dust from getting in
caused by forgetting to close the external
connector terminal cover (nP. 34).
The accompanying FOMA charger micro USB
adapter SH01/FOMA charging micro USB
adapter T01 (sold separately) is required to
charge with the AC adapter (sold separately) or
DC adapter (sold separately).
Do not charge for a long time with the power left
on. If the handset is left on after charging is
complete, the battery pack charge decreases.
In that case, the AC or DC adapter charges the
battery again. However, depending on the time
when the handset is disconnected from the AC or
DC adapter, the battery charge level may be low
or the battery may only be usable for a short
time.
If the handset is left for a long time even after the
charging is completed, the battery level may
decrease.
When the battery is empty and the handset is
being charged, charging lamp may not illuminate
immediately. However, charging is in progress.
If the battery empty alert is displayed and the
power cannot be turned on, charge the battery
for a while.
Removing battery pack
Using unnecessary force when attaching or
removing the battery pack may damage the
connector terminal for the battery pack (charger
terminal) on the handset.
With recycle
mark side up
Connector terminal
Tab
Charging
Cautions while charging
15