User Manual

104
File Management
Use infrared communication to send and
receive data to and from other handsets which
also support infrared communication.
Send and receive phonebook entries, sp-mode
mails, profiles, memos, schedules, bookmarks,
ToruCa, data shot by camera, etc.
The handset infrared communication function
complies with IrMC™ 1.1 standard. However,
depending on the data, some data may not be
sent or received even when the other party’s
handset complies with IrMC™ 1.1 standard.
The handset Ir send and receive functions
comply with IrSimple™ standard.
Infrared communication is not available in
Offline(airplane) mode.
To enter docomo application password or Lock
No. and to enter authentication code are required
for sending and receiving all data items. The
authentication code is a password exclusively for
infrared communication. Before starting data
communication, the sender and receiver must
enter the same user-specified four-digit code.
Face the Infrared ports of the receiver’s and sender’s
handset each other and set the distance between
them to approximately 20 cm or less as shown.
While doing infrared communication, keep the Infrared
ports facing each other and do not move them.
Infrared communication may not function properly in
areas of direct sunlight, directly under fluorescent
lights or near other equipment using infrared signals.
If either of the Infrared ports is dirty, infrared
communication will become difficult. Take care not to
scratch the ports, and wipe off any dirt with a soft cloth.
Insert a microSD Card in advance. However,
sending and receiving just single data may not
require the microSD Card.
When sending data, you can also operate from
each function (menu).
1
In the home screen, [R]/[Send
and Receive by Infrared]
2
Select an item
 Receive: Receive single data.
 Receive all: Receive all data.
 Send: Select data and send.
 Send all: Send all data by selecting an
application.
 Send image and video settings: Set the
format of when sending images or videos.
: Perform the operation for receiving and
sending at the same time.
: After the operation for receiving, the handset
waits to receive data. Infrared
communication automatically begins when
data is sent from sender’s handset within
approximately 30 seconds.
Infrared communication
Using infrared communication
When using infrared communication
Approx. 20 cm
or less
Infrared port
15°
15°
Sending and receiving by Infrared
28