Operating instructions

21
HT-SB300
2008 December 15
HT-SB300_A6_EN
Basic Operation
■ Subwoofer level control
Note:
When sound from the speaker is distorted, decrease the
subwoofer level.
■ Bass control
■ Treble control
■ Function
Note:
The backup function will protect the memorized function mode
for a few hours should there be a power failure or the AC power
cord becomes disconnected.
Auto power on function:
When you press the LINE / DIGITAL 1 / DIGITAL 2 button on the
remote control, the speaker will turn on at the selected function.
Auto power off and auto detect signal:
● If no analogue signal is detected within 1 minute or if “d1”/ “d2”
display is blinking for 30 seconds during power on, the
speaker will automatically go to stand-by mode. The STAND-
BY indicator turns orange.
● The speaker will automatically power ON if it detects audio
signal from connected equipment.
Dolby Pro Logic II
System expanding 2ch stereo
sound to more spacious sound.
When setting Dolby Virtual speaker
to “ON”, Dolby Pro Logic II is
activated to enjoy the stereo sound
effect.
Lights up when Dolby Pro Logic II
is activated.
The speaker level can be adjusted.
To increase the level, press the
SUBWOOFER LEVEL + button.
To decrease the level, press the
SUBWOOFER LEVEL – button.
1. Press the BASS/TREBLE button
to select “BASS”.
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the bass.
1. Press the BASS/TREBLE button
to select “TREBLE”.
2. Within 5 seconds, press the
VOLUME (+ or –) button to adjust
the treble.
-5 -4 ... 4 5
-5 +5
-5 +5
On speaker:
When the FUNCTION button is
pressed, the input source will change.
Press it repeatedly to select desired
input source.
On remote control:
Press the LINE button repeatedly to
select “L1” (LINE IN 1 input) or “L2”
(LINE IN 2 input).
LINE IN 1
LINE IN 2
DIGITAL 1
DIGITAL 2